Alderon Industries 7001 Versa’larm Manuale di funzionamento, manutenzione e installazione

Sfoglia online o scarica il pdf Manuale di funzionamento, manutenzione e installazione per Sistema di sicurezza Alderon Industries 7001 Versa’larm. Alderon Industries 7001 Versa’larm 3. Tank alarm

Stampa la pagina
7001 Versa'larm
Tank Alarm
Operation, Maintenance
and Installation Manual
Warning! Turn off all power when installing or adjusting unit. Failure to turn off all power could result in serious injury or death!
Read all instructions thoroughly! Check local codes and install to meet requirements - Refer to National Electrical Code (NFPA 70)
Alarm unit MUST be mounted indoors, failure to do so will damage unit and void warranty
Specifications
Mechanical
1/2" electrical
knockout
.18"
diameter mounting
holes(2)
Enclosure powder coated paint for indoor use
Six foot power cord
1/2" electrical knock-out
Part Number 7001 (Standard)
Description of Operation & Maintenance
The VERSA'LARM is a multipurpose alarm that can be used in a wide variety of applications such as: septic tanks, sumps, holding
tanks, pump chambers, water tanks, flow, pressure, condensate, temperature and any others where a "dry" contact can be connected
to the VERSA'LARM.
The VERSA'LARM is powered by 120 VAC coming from standard wall outlets and is transformed to 9 VDC. Installing a 9 Volt battery
provides battery back-up.
When a switch (signaling device) contact "closes" the buzzer and light will turn "on" and the optional auxiliary contacts will be activated.
Pressing the "silence" switch deactivates the buzzer and auxiliary contacts. When the alarm is remedied, the system automatically
resets itself.
Test product weekly. Make sure the green "power on" light is "on". Press the "Test" switch, the red alarm light and buzzer should turn
"on". If the battery backup system is utilized, unplug the wall mount power supply (the green light will be off). Now press the "Test"
switch, the red alarm light and buzzer will turn "on". If the buzzer sounds less loud then when tested with the normal power supply,
then replace the battery. Refer to instructions on installing/replacing the battery on page 2. Reconnect power supply when finished to
put the Versa'larm back into service.
Alarm Systems
Control Panels
PO Box 827
Hawley, MN 56549
TM
4.0"
6.0"
AC
Adaptor
Float Switches
Leak Detection Systems
(218) 483-3034
Electrical
Primary Power:
120 VAC, 50/60 HZ
Secondary Power:
Class 2, 9 VDC, 200 ma
Auxiliary Contacts:
Single Pole, Double Throw
(Optional)
Class 2, 24 VDC/24 VAC (50/60HZ),
500 ma MAXIMUM
Battery:
9 Volts (Not included)
Buzzer:
90 db @ 30 cm
103db@ 2 feet
Switch:
UL listed, 9 VDC, 200 ma minimum
(signaling device)
Single Pole, Single Throw
Model Number Nomenclature
VA
0
1
Sensor Options
0 - no sensor, alarm panel only
H - 15', Normally Open float switch
L - 15', Normally Closed float switch
Alderon Industries, LLC
P.O. Box 827
Hawley, MN 56549
Page 1 of 2
Fax (218) 483-3034
Options
1-Auxiliary Contacts, SPDT
P/N 10026 Rev B
10/28/02
Phone: 218.483.3034
Fax: 218.483.3036
Page 1 of 2
www.alderonind.com