Clarke 6500010 Operating & Maintenance Instructions - Page 6

Browse online or download pdf Operating & Maintenance Instructions for Power Tool Clarke 6500010. Clarke 6500010 14 pages. Mortising machine

Print Page

UNPACKING

Unpack the shipping carton, and

lay out the components so that

they can be clearly identified.

Check them off as follows:

A. Morticing Machine

B. Hydraulic Cylinder

D. Handle

E. 3/4" Chisel Bush

F. 5/8" Chisel Bush

G. Fence Locking Handle

I. Chuck Key

J. Allen Key - 4mm

K. Allen Key - 5mm

L. Table

M. Hold Down

N. Fence

O. Screw (2 off)

Not Shown

1. 13mm Mortice Chisel set.

2. 1/2" Chuck (Fitted)

WARNING: For your own safety, do not connect the Mortising Machine to a power

source until it is fully assembled, and you have read and understood all safety and

operational instructions.

CAUTION: Do not allow brake fluids, gasoline, penetrating oils, etc., to come in contact with

plastic parts. These solutions contain chemicals that can damage and/or destroy plastics.

Screw the Handle (D) into the hole on

the pinion shaft. (see fig.2)

Use the handle to raise the head to the

top of its' travel, and hold in place.

Secure the Hydraulic Cylinder to its' two

fittings by pushing on the spherical

housings until they click into place. One

fitting is located on the column and one

on the side of the head. The head will

now be held in position, (see fig 3).

You may now want to reposition the

handle. To do this see "Raising and

lowering the Head" on page 9.

Fig. 1

Fig. 2