Clarke CCRT266 Operation & Maintenance Instructions Manual - Page 9
Browse online or download pdf Operation & Maintenance Instructions Manual for Power Tool Clarke CCRT266. Clarke CCRT266 17 pages. Cordless rotary tool kit
Print Page
FITTING A COLLET
WARNING: MAKE SURE THAT THE BATTERY HAS BEEN REMOVED FROM THE
ROTARY TOOL BEFORE REMOVING, OR FITTING A COLLET OR ACCESSORY
The rotary tool is supplied with 4 interchangeable collets; 0.8mm - 1.6mm - 2.4mm
and 3.2mm (fitted to the rotary tool).
Select the collet to be fitted according to the shaft size of the mandrel or accessory to
be used.
To fit a collet, proceed as follows.
1. Press and hold down the spindle lock.
It may be necessary to rotate the
chuck to fully engage the spindle lock.
2. Remove the chuck by rotating the
chuck sleeve in an anti-clockwise
direction. A spanner is supplied for
this purpose.
3. Pull the collet out of the spindle.
4. Insert the collet required, pushing it
into the spindle as far as it will go.
5. Refit the chuck, pressing the spindle
lock to tighten it.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
9