Clarke CCRT266 운영 및 유지보수 지침 매뉴얼 - 페이지 9

{카테고리_이름} Clarke CCRT266에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CCRT266 17 페이지. Cordless rotary tool kit

FITTING A COLLET

WARNING: MAKE SURE THAT THE BATTERY HAS BEEN REMOVED FROM THE

ROTARY TOOL BEFORE REMOVING, OR FITTING A COLLET OR ACCESSORY

The rotary tool is supplied with 4 interchangeable collets; 0.8mm - 1.6mm - 2.4mm

and 3.2mm (fitted to the rotary tool).

Select the collet to be fitted according to the shaft size of the mandrel or accessory to

be used.

To fit a collet, proceed as follows.

1. Press and hold down the spindle lock.

It may be necessary to rotate the

chuck to fully engage the spindle lock.

2. Remove the chuck by rotating the

chuck sleeve in an anti-clockwise

direction. A spanner is supplied for

this purpose.

3. Pull the collet out of the spindle.

4. Insert the collet required, pushing it

into the spindle as far as it will go.

5. Refit the chuck, pressing the spindle

lock to tighten it.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]