Clarke CCRT266 운영 및 유지보수 지침 매뉴얼 - 페이지 10

{카테고리_이름} Clarke CCRT266에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CCRT266 17 페이지. Cordless rotary tool kit

FITTING AN ACCESSORY

IMPORTANT: Ensure the tool is switched OFF

TO FIT AN ACCESSORY, PROCEED AS FOLLOWS.

1. Make sure that the correct size collet has been fitted.

2. Press and hold down the spindle lock.

• It may be necessary to rotate the

chuck to fully engage the spindle

lock.

3. Rotate the chuck sleeve in an

anticlockwise direction until the collet

jaws are open sufficiently to accept

the accessory.

4. Insert the accessory into the collet as

far as it will go.

5. Press and hold down the spindle lock

and tighten the chuck sleeve using

the spanner supplied.

TO REMOVE THE ACCESSORY FROM THE COLLET, PROCEED AS FOLLOWS.

1. Press and hold down the spindle lock.

2. Using the spanner supplied, rotate the chuck sleeve in an anti-clockwise direction.

3. When the accessory is released, remove it.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]