Zanussi BMS 841 Instruction Booklet - Page 13

Browse online or download pdf Instruction Booklet for Oven Zanussi BMS 841. Zanussi BMS 841 16 pages. Built-in ovens bm96; bms841
Also for Zanussi BMS 841: Instruction Booklet (16 pages), Instruction Booklet (32 pages), Instruction Booklet (21 pages), Instruction Booklet (16 pages)

Print Page

The Oven Door

Before cleaning the oven door, we recommend you to

remove it from the oven.

Proceed as follows:

a) open the oven door completely;

b) find the hinges linking the door to the oven;

c) unlock and turn the small levers located on the two

hinges;

d) handle the door by its left- and right-hand sides,

then slowly turn it towards the oven until it is half-

closed;

e) gently pull the oven door off its site;

f) place it on a steady plan.

Clean the oven door glass with warm water and a softh

cloth only.

Once the cleaning is carried out, refit the oven door,

following the procedure in reverse.

For the BMS 841 X and BM 96 EX models, we

recommend to clean the outer surface of the oven door

with a wet sponge, and then carefully wipe it dry with a soft

cloth. Do not use any abrasive cleaning product, such as

steel wool or acids, as they could damage the stainless

steel surface.

Follow the same procedure for the control panel.

Grease Filter

To prevent a build-up of fats on the fan impellor, the grease

filter must be fitted by clipping it over the vents in the back

panel.

To clean the grease filter

When the oven has cooled down, remove the filter by

pushing the protruding tongue on the filter upward, and

wash carefully.

The grease filter should be cleaned after every use. The

filter may be washed in a dishwasher on a 65°C wash. If

the filter is heavily soiled, place the filter in a saucepan of

water with approximately 1 teaspoon of automatic washing

powder or dishwasher powder. Bring to the boil and leave

to soak for approximately 30 minutes or longer depending

on the degree of soiling. Ensure the solution does not boil

over as it could mark your hob.

Rinse filter in clear water and dry.

Remember to refit the filter before using the oven again.

Replacing the Oven Light

If the oven bulb needs replacing, it must comply with the

following specifications:

- Electric power: 25W,

- Electric rate: 230 V (50 Hz),

- Resistant to temperatures of 300°C,

- Connection type: E14.

These bulbs are available from your local Service Centre.

To replace the faulty bulb:

1. Ensure the oven is isolated from the electrical supply.

2. Turn the glass cover anticlockwise.

3. Remove the faulty bulb and replace with the new one.

4. Refit the glass cover.

5. Restore the electrical supply.

All manuals and user guides at all-guides.com

FO 0287