Zanussi ZT 695 Instruction Book - Page 22

Browse online or download pdf Instruction Book for Dishwasher Zanussi ZT 695. Zanussi ZT 695 24 pages. Zanussi instruction dishwasher zt 695

Print Page

The waste connection must be at a height of between 30 cm

(minimum) and 100 cm (maximum) from the bottom of the

dishwasher.

The drain hose can face either to the right or left of the

dishwasher

Ensure the hose is not bent or squashed as this could

prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer than 2

metres and its internal diameter must be no smaller than the

diameter of the hose provided.

Likewise the internal diameter of the couplings used for

connections to the waste outlet must be no smaller than the

diameter of the hose provided.

The sink plug must not be in place when the machine is

draining as this could cause the water to siphon back into

the machine.

Electrical connection

This appliance must be earthed.

The manufacturer declines any responsibility

should this safety measure not be observed.

If the plug that is fitted to your appliance is not suitable for

the socket, it must be cut off and the appropriate plug fitted.

Important

The wires on the mains lead are coloured in accordance

with the following code:

Green and Yellow

-Earth

Blue

-Neutral

Brown

-Live

If you fit your own plug, the colours of the wires in the mains

lead of your appliance may not correspond with the

markings identifying the terminals in your plug.

Proceed as follows:

1. Connect the Green and Yellow (earth) wire to the

terminal in the plug which is marked with the letter "E" or

the earth symbol

or coloured green and yellow.

2. Connect the Blue (neutral) wire to the terminal in the

plug which is marked with the letter "N" or coloured

black.

3. Connect the Brown (live) wire to the terminal in the plug

which is marked with the letter "L" or coloured red.

The plug moulded onto the lead incorporates a 13amp

BSI362 fuse. Only ASTA or BSI fuses should be used.

The plug must not be used if the fuse cover/carrier is lost.

The cover/carrier is indicated by the coloured insert at the

base of the product.

A replacement cover/carrier must be obtained from your

local Service Force Centre.

This appliance complies with the following E.E.C.

Directives:

- 73/23 or 19.2.73 (Low Voltage Directive) and

subsequent modifications;

- 89/336 or 3.5.89 (Electromagnetic Compatibility

Directive) and subsequent modifications.

CS10

CE03

+ 2 m max