Zanussi ZEV6140XBA User Manual - Page 18
Browse online or download pdf User Manual for Hob Zanussi ZEV6140XBA. Zanussi ZEV6140XBA 44 pages.
Print Page
Problem
Residual heat indicator does not
come on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
Installation
WARNING!
Refer to Safety chapters.
Before the installation
Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
18
Possible cause
The fuse is blown.
The zone is not hot because it
operated only for a short time.
surface). Make sure, you operated the hob
correctly. If not the servicing by a service
technician or dealer will not be free of charge,
also during the warranty period. The instructions
about the Service Centre and conditions of
guarantee are in the guarantee booklet.
Connection cable
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use
Make sure that the fuse is the
cause of the malfunction. If the
fuse is blown again and again,
contact a qualified electrician.
If the zone operated sufficiently
long to be hot, speak to an Au-
thorised Service Centre.
the following (or higher) mains cable type:
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
Remedy
www.zanussi.com