Zanussi ZEV6140XBA Gebruikershandleiding - Pagina 18

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Zanussi ZEV6140XBA. Zanussi ZEV6140XBA 44 pagina's.

Problem

Residual heat indicator does not

come on.

If you cannot find a solution...

If you cannot find a solution to the problem

yourself, contact your dealer or an Authorised

Service Centre. Give the data from the rating

plate. Give also three digit letter code for the

glass ceramic (it is in the corner of the glass

Installation

WARNING!

Refer to Safety chapters.

Before the installation

Before you install the hob, write down the

information bellow from the rating plate. The

rating plate is on the bottom of the hob.

Serial number ...........................

Built-in hobs

Only use the built-in hobs after you assemble

the hob into correct built-in units and work

surfaces that align to the standards.

Possible cause

The fuse is blown.

The zone is not hot because it

operated only for a short time.

surface). Make sure, you operated the hob

correctly. If not the servicing by a service

technician or dealer will not be free of charge,

also during the warranty period. The instructions

about the Service Centre and conditions of

guarantee are in the guarantee booklet.

Connection cable

• The hob is supplied with a connection cable.

• To replace the damaged mains cable use

Make sure that the fuse is the

cause of the malfunction. If the

fuse is blown again and again,

contact a qualified electrician.

If the zone operated sufficiently

long to be hot, speak to an Au-

thorised Service Centre.

the following (or higher) mains cable type:

H05V2V2-F T min 90°C. Speak to your local

Service Centre.

Remedy