Zanussi ZGG76524XA User Manual - Page 21
Browse online or download pdf User Manual for Hob Zanussi ZGG76524XA. Zanussi ZGG76524XA 45 pages. Zanussi cooktop user manual
Also for Zanussi ZGG76524XA: User Manual (16 pages)
Print Page
ELECTRICAL CONNECTION
•
Make sure that the rated voltage and type of
power on the rating plate agree with the voltage
and the power of the local power supply.
•
This appliance is supplied with a mains cable. It
has to be supplied with a correct plug which
can hold the load that the rating plate rates.
Make sure that you install the plug in a correct
socket.
•
Always use a correctly installed shockproof
socket.
•
Make sure that there is an access to the mains
plug after the installation.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
•
There is a risk of fire when the appliance is in
connection with an extension cable, an adapter
or a multiple connection. Make sure that the
ground connection agrees with the standards
and regulations.
•
Do not let the power cable to heat up to a
temperature higher than 90° C.
Make sure that you connect the blue
neutral cable to the terminal with a
letter "N" on it. Connect the brown (or
black) phase cable to the terminal
which has a letter "L". Keep the phase
cable connected at all times.
CONNECTION CABLE
To replace the connection cable use only the
special cable or its equivalent. The cable type is:
H05V2V2-F T90.
Make sure that the cable section is applicable to
the voltage and the working temperature. The
yellow / green earth wire must be approximately 2
cm longer than the brown (or black) phase wire.
BUILDING IN
min.
450 mm
min.
55 mm
30 mm
480 mm
min.
650 mm
560 mm
10 mm
3 mm
A. supplied seal
B. supplied brackets
CAUTION! Install the appliance only
on a worktop with flat surface.
POSSIBILITIES FOR INSERTION
The panel installed below the hob must be easy to
remove and let an easy access in case a technical
assistance intervention is necessary.
Kitchen unit with door
A
86 mm
86 mm
A
B
min 6 mm
21