Zanussi ZFC21410WE User Manual - Page 8

Browse online or download pdf User Manual for Freezer Zanussi ZFC21410WE. Zanussi ZFC21410WE 12 pages.

Print Page

Periods of non-operation

When the appliance is not in use for long

periods, take the following precautions:

1. Switch off the appliance and disconnect the

appliance from electricity supply.

2. Remove all food

3. Defrost and clean the appliance and all

accessories.

Troubleshooting

WARNING!

Refer to Safety chapters.

What to do if...

Problem

The appliance does not operate.

The appliance is noisy.

Audible or visual alarm is on.

Power indicator light is flashing.

The lid doesn't close completely.

The lid is difficult to open.

The compressor operates contin-

ually.

4. Leave the lid open to prevent unpleasant

Possible cause

The appliance is switched off.

The mains plug is not connected

to the mains socket correctly.

There is no voltage in the mains

socket.

The appliance is not supported

properly.

The cabinet has been recently

switched on or the temperature

in the appliance is too high.

An error has occurred in measur-

ing the temperature or the appli-

ance is not working properly.

Food packages are blocking the

lid.

There is excessive frost.

The lid gaskets are dirty or sticky. Clean the lid gaskets.

The valve is blocked.

Temperature is set incorrectly.

Large quantities of food to be

frozen were put in at the same

time.

smells.

If the cabinet will be kept on, ask

somebody to check it once in a

while to prevent the food inside from

spoiling in case of a power failure.

Switch on the appliance.

Connect the mains plug to the

mains socket correctly.

Connect to a different electrical

mains socket. Contact a qualified

electrician.

Check if the appliance stands

stable.

Refer to "High Temperature

Alarm" and if the problem still oc-

curs contact the nearest Author-

ized Service Centre.

Contact the nearest Authorized

Service Centre.

Arrange the packages in the right

way, see the sticker in the appli-

ance.

Eliminate excess frost.

Check the valve.

Refer to "Operation" chapter.

Wait some hours and then check

the temperature again.

Solution