Zanussi ZFC21410WE Посібник користувача - Сторінка 8
Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера Zanussi ZFC21410WE. Zanussi ZFC21410WE 12 сторінок.
Друкувати сторінку
Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Switch off the appliance and disconnect the
appliance from electricity supply.
2. Remove all food
3. Defrost and clean the appliance and all
accessories.
Troubleshooting
WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
Audible or visual alarm is on.
Power indicator light is flashing.
The lid doesn't close completely.
The lid is difficult to open.
The compressor operates contin-
ually.
8
4. Leave the lid open to prevent unpleasant
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
The cabinet has been recently
switched on or the temperature
in the appliance is too high.
An error has occurred in measur-
ing the temperature or the appli-
ance is not working properly.
Food packages are blocking the
lid.
There is excessive frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked.
Temperature is set incorrectly.
Large quantities of food to be
frozen were put in at the same
time.
smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside from
spoiling in case of a power failure.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect to a different electrical
mains socket. Contact a qualified
electrician.
Check if the appliance stands
stable.
Refer to "High Temperature
Alarm" and if the problem still oc-
curs contact the nearest Author-
ized Service Centre.
Contact the nearest Authorized
Service Centre.
Arrange the packages in the right
way, see the sticker in the appli-
ance.
Eliminate excess frost.
Check the valve.
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Solution
www.zanussi.com