Zanussi ZRB934FW2 User Manual - Page 9
Browse online or download pdf User Manual for Freezer Zanussi ZRB934FW2. Zanussi ZRB934FW2 16 pages. Fridge freezer
Print Page
Troubleshooting
Caution! Before troubleshooting, disconnect the
power supply.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Problem
The appliance is noisy.
The appliance does not operate.
The light device does not work.
The compressor operates contin-
ually.
Water flows on the rear plate of
the refrigerator.
Water flows into the refrigerator.
Water flows on the ground.
The temperature in the appliance
is too low/high.
If your appliance is still not working properly after making
the above checks, contact the After Sales Centre. You can
find the list at the end of this manual.
Replacing the control unit
The appliance is equipped with a longlife LED interior
light.
www.zanussi.com
Possible cause
The appliance is not installed properly. Check if the appliance stands stable (all
The plug is not connected to the mains
socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The light device is in stand-by.
The unit is defective.
The temperature is not set correctly.
The door is not closed correctly.
The door has been opened too fre-
quently.
The food temperature is too high.
The room temperature is too high.
During the automatic defrosting proc-
ess, frost defrosts on the rear plate.
The water outlet is clogged.
Products prevent that water flows into
the water collector.
The melting water outlet does not flow
in the evaporative tray above the com-
pressor.
The temperature regulator is not set
correctly.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
the feet should be on the floor).
Connect the plug to the mains socket
correctly.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the control unit".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer than
necessary.
Let the food temperature decrease to
room temperature before storage.
Decrease the room temperature.
This is correct.
Clean the water outlet.
Make sure that products do not touch
the rear plate.
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Only service is allowed to replace the control unit. Contact
your Service Center.
Closing the door
1.
Clean the door gaskets.
2.
If necessary, replace the defective door gaskets.
Contact the After Sales Service.
Solution
9