Directed Directechs DB3 Installation Manual - Page 10

Print Page

Module programming

Refer to "LED diagnostics and troubleshooting" for more information and for troubleshooting purposes.

IMPORTANT!

Before programming your module, you must first check if your vehicle is equipped with an OEM

remote starter and disable it. If the vehicle is equipped with an OEM remote starter, whether Active or Inactive,

MUST

be temporarily disabled or permanently disconnected depending on the vehicle Please refer to the

"OEM remote starter information" section of the guide for additional details.

Note:

In some cases, the module will program to the vehicle even if equipped with an OEM starter, but will

prevent the aftermarket remote start from functioning properly.

Wait until the LED turns ON solid red.

Wait 4 seconds before turning the ignition ON.

The LED flashes orange if an OEM remote starter is detected. Refer to "OEM remote starter

detection" for more information.

Press the Push-to-Start (PTS) button twice to turn the ignition ON. The LED turns ON solid

green for 3 seconds, then shuts OFF.

If the LED flashes orange, press the programming button 5 times. The LED turns ON solid

orange for 3 seconds to indicate the programming is completed. Otherwise, proceed to the

next step.

Press the PTS button once more to turn the ignition OFF.

You have successfully completed the module programming sequence.

403.TL6 2.26 2018 Toyota RAV4 Hybrid (Smart Key)