Blackberry RADAR H2 ITC100-1 Installation Manual - Page 7

Browse online or download pdf Installation Manual for Radar Blackberry RADAR H2 ITC100-1. Blackberry RADAR H2 ITC100-1 30 pages. Magnet accessory
Also for Blackberry RADAR H2 ITC100-1: Installation Manual (33 pages), Installation Manual (28 pages), Installation Manual (35 pages), Installation Manual (25 pages), Installation Manual (35 pages)

Print Page
Blackberry RADAR H2 ITC100-1 Installation Manual
3. Once you have identified the desired mounting location for your asset, mark the
height where the device will be installed on the door of the trailer/container.
It is recommended that you install the module as level as possible on the asset. To
help ensure the device is level, you may try this technique.
Make one mark at the desired placement height.
•
Make a second mark, at the same height, approximately 4 inches (100mm) to
•
the side of the first mark.
Draw a straight line between the two points. This will help ensure your line is
•
parallel to the bottom of the door.
4. Remove the adhesive from the rear of the template and place the template in the
desired installation location. The adhesive at the back of the template ensures that it
stays on the door surface for accurate drilling of your holes.
BLACKBERRY RADAR H2 ITC100-1 INSTALLATION GUIDE 37