aerauliqa CTRL-XWS Instruction Manual - Page 16

Browse online or download pdf Instruction Manual for Controller aerauliqa CTRL-XWS. aerauliqa CTRL-XWS 20 pages.

Print Page

4.2.4 MANUAL CONTROL

Press both

and

for about 5 seconds.

Four lines are shown on the display and then the % of the 0-10V regulation.

Release

and

(the led of the two buttons flash).

Press

to increase the regulation value.

Press

to decrease the regulation value.

The regulation % remains fixed at the desired point.

BACK TO THE AUTOMATIC MODE

Press both

and

for about 5 seconds.

Four lines are shown on the display and then the ambient temperature is displayed (the leds of the two buttons switch off).

4.2.5 SETTING OF THE CONSTANT DATA

Press both

and

for about 5 seconds.

Four lines are shown on the display and then the message CONF. is displayed.

Press

to scroll the setting menu.

Parameters:

P.r.o.b.

Cor.t. = temperature probe correction

SCAL = °C/°F Celsius or Fahrenheit degree

Air

SP.Lo = % of minimum speed

SP.Hi = % of the maximum speed

P.b. = proportional band of regulation

t.Lo.A = minimum temperature alarm

t.Hi.A = maximum temperature alarm

d.SE.t = temperature alarm relays hysteresis

AnEM.=0-1 activation/deactivation wind block

d.SE.r = on/off anemometer block hysteresis

t.Int. = 0-10V integration time

ImP. = number of pulses per revolution

Circ. = blade circumference

Unit = unit of measure 0=m/s 1=mph 2=km/h

Star = % minimum starting speed

4.3 ANEMOMETER BLOCK

Press twice

: the anemometer block setting ( SET = 3.0v) is displayed.

Press

to increase / decrease.

By activating in CONF. the function (ANEM.=1) and by connecting the anemometer, when the wind speed goes over the set level, the 0-10V signal is inhibited.

4.4 MEMORY OF THE REGISTERED TEMPERATURE (the values are retained even with the controller switched off)

Press

: the diagram is displayed followed by the maximum registered temperature value. Keeping

CLEA. is shown and the memory is cleared.

Press

: the diagram is displayed followed by the minimum registered temperature value. Keeping

CLEA. is shown and the memory is cleared.

4.5 SYSTEM RESET

Disconnect the controller from the main power supply.

Connect the controller to the main power supply and keep

Release

and wait for the reset.

Attention: Any setting will return to the default.

pressed until the word BOOT is displayed.

pressed for more than 3 seconds, the word