Clarke Woodworker CS6-9C Operating & Maintenance Manual - Page 5
Browse online or download pdf Operating & Maintenance Manual for Sander Clarke Woodworker CS6-9C. Clarke Woodworker CS6-9C 15 pages. Belt & disc sander belt & disc sander
Print Page
ELECTRICAL CONNECTIONS
Connect the mains lead to a standard, 230 volt (50Hz) electrical supply through a
fused good quality 13 amp BS 1363 plug, or a suitable fused isolator switch.
WARNING: THIS APPLIANCE MUST BE EARTHED
IMPORTANT: The wires in the mains lead are coloured in accordance with the
following code:
Green & Yellow
As the colours of the flexible cord of this appliance may not correspond with the
coloured markings identifying terminals in your plug, proceed as follows:
•
Connect GREEN & YELLOW cord to terminal marked with a letter "E" or Earth
symbol "
" or coloured GREEN or GREEN & YELLOW.
•
Connect BROWN cord to terminal marked letter "L" or coloured RED.
•
Connect BLUE cord to terminal marked letter "N" or coloured BLACK.
We strongly recommend that this unit is fitted with a Residual Current Device (RCD).
FUSE RATING
The fuse in the plug for this appliance must be rated at 13 amps and any
replacement must be ASTA approved to BS1362.
IMPORTANT NOTICE
If this appliance is fitted with a plug which is moulded on to the electric cable (i.e.
non rewireable) please note:
1.
This plug must be thrown away if it is cut from the electric cable. There is a
danger of electric shock if it is subsequently inserted in a socket outlet.
2.
Never use the plug without the fuse cover fitted.
3.
Should you wish to replace a detachable fuse carrier, ensure that the correct
replacement is used (as indicated by marking or colour code).
4.
Replacement fuse covers can be obtained from your local dealer, or an
electrical stockist.
5.
The fuse in the plug must be 13Amps,
-
Earth
Blue
-
Neutral
Brown
-
Live
- 5 -