Clarke CAT151 Operating & Maintenance Instructions - Page 8

Browse online or download pdf Operating & Maintenance Instructions for Tools Clarke CAT151. Clarke CAT151 17 pages. Air/hydraulic riveter

Print Page

3. Check the jaw stroke by using the

spanner/gauge as in figs 5 and 6.

4. Set the distance to < 70 mm i.e. the

length of the spanner gauge as

shown.

5. If necessary, adjust the stroke as

follows:

• Hold the rear jaw case (fig 7)

with the larger spanner and

loosen the lock nut with the

spanner/gauge.

• Adjust the stroke by rotating the

jaw case assembly and

tightening the lock nut when

adjustment is complete.

6. Refit the outer cylinder.

CONNECTING THE AIRLINE

NOTE: Ensure the air compressor is turned off.

1. Remove the protective plug from

the air inlet port and connect a

suitable hose as shown.

2. Connect the other end of the hose

to the compressor.

3. Turn on the air supply and check

for air leaks. Rectify any leaks

found before proceeding.

• PTFE tape may be helpful for

sealing threaded connections.

4. If required, connect an in-line mini oiler into the air supply line to the tool.

• A mini oiler helps to prolong the life of the air tool.

• If a mini-oiler is not being used, run a few drops of oil through the tool

before use. It can be entered through the inlet connector or via the

hose at the nearest connection to the air supply.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]