Clarke CEA150 Operating & Maintenance Instructions - Page 8

Browse online or download pdf Operating & Maintenance Instructions for Tools Clarke CEA150. Clarke CEA150 13 pages. 150mm electric earth borer

Print Page

USING THE AUGER

1. Put the point of the auger at the

location of the hole.

2. Depress the safety button and

slowly squeeze the trigger to start

the machine.

• The auger bit will start rotating.

3. Apply a light downward pressure

to drill the hole.

4. Periodically, raise the auger to

help clear drilling debris from the hole.

NOTE: Overloading the auger during use can cause it to stop turning. If

this occurs, lift the auger to decrease the load on the motor and

allow material to be lifted out of the hole before you continue.

MAINTENANCE

WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE

CLEANING OR PERFORMING ANY MAINTENANCE TASKS.

CLEANING

1. Keep the surface of your machine free of dirt. Use a cloth dampened with

soapy water. Do not use petroleum based solvents or abrasives. Never

immerse the machine in any liquid.

2. The Auger bit should be removed and cleaned separately.

3. If the motor/drive mechanism does not operate, it needs to be serviced or

replaced by a qualified technician.

4. Store the machine in a secure, dry place, out of reach of children.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]