Clarke CONTRACTOR 6462118 Operation & Maintenance Instructions Manual - Page 13
Browse online or download pdf Operation & Maintenance Instructions Manual for Tools Clarke CONTRACTOR 6462118. Clarke CONTRACTOR 6462118 20 pages. Worktop jig
Print Page
Fig. 15
Post Form Edge
Cut Direction
4. Ensure the 2 pins in holes 'F' are pushed firmly against the post form edge of the
worktop, clamp the jig to the worktop ensuring clamps do not obstruct the router
path.
5. Once the cut is complete, remove the excess (Fig. 16 hatched area), using either
the router or a fine tooth saw.
Cutting
6.
- Follow steps 6 - 9 on page 6.
Fig. 16
Male Joint (Fig. 17)
7.
care to protect the surface.
8. Fully insert two pins in the jig holes marked 'M' with angle symbol
9. Refer to page 10, (cutting to length) to determine where to mark the pencil line for
positioning the jig on the worktop.
10. Ensure the 2 pins in holes marked 'M' are pushed firmly against the post form edge
and the jig on the pencil line (Fig. 17).
Female joint - laminate face up.
- Place the worktop with the laminate face down, taking
700mm
.
-12-