Clarke CONTRACTOR 6462118 운영 및 유지보수 지침 매뉴얼 - 페이지 13

{카테고리_이름} Clarke CONTRACTOR 6462118에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR 6462118 20 페이지. Worktop jig

Fig. 15

Post Form Edge

Cut Direction

4. Ensure the 2 pins in holes 'F' are pushed firmly against the post form edge of the

worktop, clamp the jig to the worktop ensuring clamps do not obstruct the router

path.

5. Once the cut is complete, remove the excess (Fig. 16 hatched area), using either

the router or a fine tooth saw.

Cutting

- Follow steps 6 - 9 on page 6.

Fig. 16

Male Joint (Fig. 17)

care to protect the surface.

8. Fully insert two pins in the jig holes marked 'M' with angle symbol

9. Refer to page 10, (cutting to length) to determine where to mark the pencil line for

positioning the jig on the worktop.

10. Ensure the 2 pins in holes marked 'M' are pushed firmly against the post form edge

and the jig on the pencil line (Fig. 17).

Female joint - laminate face up.

- Place the worktop with the laminate face down, taking

700mm

-12-