Clarke CONTRACTOR 6462118 운영 및 유지보수 지침 매뉴얼 - 페이지 15
{카테고리_이름} Clarke CONTRACTOR 6462118에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR 6462118 20 페이지. Worktop jig
페이지 인쇄
Male Bolt Recesses (Fig. 19)
18.
19. Fully insert 3 pins in the holes marked 'CB'.
20. Clamp the jig to the worktop ensuring all 3 pins are pushed firmly against the
worktop. Ensure clamps do not obstruct the router path.
21. Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router to
the back again. Increase the depth of cut a further 10mm and machine the recess
again. When finished, switch the router OFF and wait for it to stop spinning.
22. Repeat step 21 for the other 2 recesses (other 3 recesses for 900mm worktops).
Recesses must be no deeper than 20mm maximum.
Right Hand 45º Joints
Female joint (Fig. 20)
1.
Prepare the worktop with the laminate face down and the post form edge towards
the left.
2. Fully insert 2 pins in the holes marked 'F'.
3. Position the jig as in Fig. 15 so that when the cut has been made, there is sufficient
length to enable trimming to length, see Fig. 16 page 12.
4. Ensure the 2 pins in holes 'F' are pushed firmly against the post form edge of the
worktop, clamp the jig to the worktop ensuring clamps do not obstruct the router
path.
5. Once the cut is complete, cut off the excess, see Fig. 16.
Cutting
6.
- Follow steps 6 - 9 on page 6.
To Prevent damage to the laminate surface, take
extra care when working with laminate face down.
- Place the worktop with laminate face down.
Male bolt recesses -
Laminate face down.
IMPORTANT
- Refer to the diagrams on the different joints available.
CAUTION
Post Form Edge
Fig. 19
-14-