Clarke CONTRACTOR 6462118 운영 및 유지보수 지침 매뉴얼 - 페이지 14
{카테고리_이름} Clarke CONTRACTOR 6462118에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CONTRACTOR 6462118 20 페이지. Worktop jig
페이지 인쇄
Fig. 17
11. Firmly clamp the jig to the worktop ensuring it doesn't move as you do so. Ensure the
clamps do not obstruct the router path.
Cutting
12.
- Follow steps 6 - 9 on page 6.
Female Bolt Recesses (Fig. 18)
13.
14. Fully insert three pins in holes marked 'CB'.
15. Clamp the jig to the worktop ensuring the three pins are firmly pushed up to the cut
out face and the worktop edge. Ensure clamps do not obstruct the router path.
16. Place the router into the front of one of the clamp bolt recesses, set the depth of
cut to 10mm max. Switch the router ON and machine the recess. When done,
switch the router OFF and wait for the cutter to stop spinning. Return the router to
the back again. Increase the depth of cut a further 10mm and machine the recess
again. When finished, switch the router OFF and wait for it to stop spinning.
17. Repeat step 16 for the other 2 recesses (other 3 recesses for 900mm worktops).
Recesses must be no deeper than 20mm maximum.
Female bolt recesses - Laminate face down.
Post Form Edge
-13-
Pencil Line
Male Joint - Laminate face down.
- Place the worktop with the laminate face down.
IMPORTANT
Cut Direction
Post Form Edge
Fig. 18