Nikon A1+ User Manual - Page 10

Browse online or download pdf User Manual for Microscope Nikon A1+. Nikon A1+ 28 pages. Lbic nikon confocal
Also for Nikon A1+: Standard Operating Procedure (15 pages)

Print Page

Optimising scan settings for best image quality

1. Press the Scan button (lasers scan and the live image is constantly

refreshed). Pressing Scan again will stop the scanning process.

2. The Find button can be used to increase the live image refresh rate by

decreasing the size of the scanned area and the image quality. Use

this option if you cannot find the sample by scanning with the

continuous Scan button.

3. Each detector, signified by the coloured band and labelled with the fluorophore

name in the compact GUI, generates its own image. The Live window shows the

merged colour image of all the active detectors.

4. The default detector settings, HV (Gain), Offset and Laser power are set

conservatively. If the live window is black this usually means the detector settings

need to be adjusted.

5. It is recommended that you optimise one channel (detector) at a time. An easy way

to do this is to enable the Channel Setup tick box. When selected the square tick

box next to each detector changes to a radio button (circle), the active detector is

the one with the filled in grey circle. You can toggle between the different channels

by clicking in the circle next to the channel heading.

6. Note that when Channel Setup is enabled you will only see the image generated by

that selected detector.

7. If the image is black you can raise the HV (Gain) of the detector to a higher value

until you can see an image. Alternatively you can use the AutoGain (AG) button at

the top of the Compact GUI to calculate the optimal Gain value based on the

current laser power.

8. Note that increasing gain leads to increased image noise and eventually a lower

signal to noise ratio (SNR). Therefore the best image quality is usually attained by

adjusting several parameters, namely the gain, laser power and the scan speed.

9. Keep laser power as low as possible to minimise bleaching of the sample. Gain

should be set so that image noise is negligible. Offset at zero and scan speed 6.2

pixel dwell or faster.