Armstel MDA2120-A User Manual - Page 14

Browse online or download pdf User Manual for Monitor Armstel MDA2120-A. Armstel MDA2120-A 19 pages.

Print Page

5) Double click to run ARMSTEL Amedicom

during the calibration, make sure that Simlux

Calispector

operating window, and the window should be sufficiently big to cover the whole

meter during the whole calibration process for the accurate calibration;

For the use of Calispector

Manual.

Note: user needs to make sure using the right luminance table and the corresponding BARTEN

table generated by the software to set the LCD display in the calibration.

5. Trouble Shooting

If a problem persists even after applying the suggested remedies, contact a dealer.

Problems

1. No picture

Indicator status: Off

Indicator status: Orange

2. The screen is too bright or too

dark.

3.Image sticking issue appears.

4. The screen has defective pixels

(e.g. slightly light or dark).

6. Cleaning

Periodic cleaning is recommended to keep the monitor clean and to prolong its operation lifetime.

Note: Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or

other strong solvents, as these may cause damage to the cabinet or LCD panel.

Cabinet

To remove stains, wipe the cabinet with a soft, lightly moistened cloth using a mild detergent. Do not spray

wax or cleaner directly into the cabinet.

LCD Panel

The LCD surface can be cleaned with a soft cloth, such as cotton or lens paper.

If necessary, stubborn stains can be removed by moistening part of a cloth with water to enhance its

cleaning power.

Calispector

, please refer to ARMSTEL home page for Calispector

Points to check with Possible Solutions

Check if the power cord is correctly connected. If the problem

persists, turn off the monitor for a few minutes, then turn it on and

try again.

Press the keyboard of computer or click the mouse, turn off the

monitor and then restart.

Adjust the <Brightness> (The backlight of the LCD monitor has a

fixed life span. When the screen becomes dark or begins to

flicker, please contact your dealer.)

- Please check if you use the screen saver or timer when

displaying the same image for long time.

- Image sticking is inherent characteristic of the panel. Avoid

displaying the same image for long time.

This is due to the characteristics of the panel itself, not the LCD

monitor.

-14-

MDA2120-A/MDA2120-S

software installed above. Note,

meter is sitting in the middle of the

User Manual

User