Armstel MDA2120-A Руководство пользователя - Страница 14

Просмотреть онлайн или скачать pdf Руководство пользователя для Монитор Armstel MDA2120-A. Armstel MDA2120-A 19 страниц.

5) Double click to run ARMSTEL Amedicom
during the calibration, make sure that Simlux
TM
Calispector
operating window, and the window should be sufficiently big to cover the whole
meter during the whole calibration process for the accurate calibration;
For the use of Calispector
Manual.
Note: user needs to make sure using the right luminance table and the corresponding BARTEN
table generated by the software to set the LCD display in the calibration.

5. Trouble Shooting

If a problem persists even after applying the suggested remedies, contact a dealer.
Problems
1. No picture
Indicator status: Off
Indicator status: Orange
2. The screen is too bright or too
dark.
3.Image sticking issue appears.
4. The screen has defective pixels
(e.g. slightly light or dark).

6. Cleaning

Periodic cleaning is recommended to keep the monitor clean and to prolong its operation lifetime.
Note: Never use thinner, benzene, alcohol (ethanol, methanol, or isopropyl alcohol), abrasive cleaners, or
other strong solvents, as these may cause damage to the cabinet or LCD panel.
Cabinet
To remove stains, wipe the cabinet with a soft, lightly moistened cloth using a mild detergent. Do not spray
wax or cleaner directly into the cabinet.
LCD Panel
The LCD surface can be cleaned with a soft cloth, such as cotton or lens paper.
If necessary, stubborn stains can be removed by moistening part of a cloth with water to enhance its
cleaning power.
®
Calispector
TM
TM
, please refer to ARMSTEL home page for Calispector
Points to check with Possible Solutions
Check if the power cord is correctly connected. If the problem
persists, turn off the monitor for a few minutes, then turn it on and
try again.
Press the keyboard of computer or click the mouse, turn off the
monitor and then restart.
Adjust the <Brightness> (The backlight of the LCD monitor has a
fixed life span. When the screen becomes dark or begins to
flicker, please contact your dealer.)
- Please check if you use the screen saver or timer when
displaying the same image for long time.
- Image sticking is inherent characteristic of the panel. Avoid
displaying the same image for long time.
This is due to the characteristics of the panel itself, not the LCD
monitor.
-14-
MDA2120-A/MDA2120-S
TM
software installed above. Note,
meter is sitting in the middle of the
User Manual
TM
User