DISCO DFP8160 Technical Newsletter - Page 2

Browse online or download pdf Technical Newsletter for Grinder DISCO DFP8160. DISCO DFP8160 5 pages. Request for periodic replacement brush/leveling stone (t2 pad washing unit [optional accessory])

Print Page
Technical Newsletter
Replacement of Brush/Leveling Stone
(T2 Pad Washing Unit [Optional Accessory])
Necessary tool
Allen wrench
Procedures to replace the brush/leveling stone of the T2 pad washing unit
When replacing the leveling stone, do not loosen or adjust the 3 set screws in
the image below
The 3 set screws in the image below are for adjusting the level of the leveling stone. If
you adjust the set screws, there is a risk that the leveling stone will not press against
the T2 pad and it will not be possible to perform T2 pad cleaning appropriately.
Hexagon socket head cap
screw
Step No.
Connect the handy panel at the Z1 side.
1
Move the brush of the washing unit to the washing (center) position.
2
→Refer to Section 2-3-8, [Operation Screens for Washing Unit] of Chapter G in the
Display the operation screen for the transfer arm 2.
3
#tnl2019-0008e-rev1
# 2 / 5
Set screw
Maintenance Manual for operation details of the washing unit.
R
Z:
INITIAL
SEQUENCE
CAUTION
Procedure
#300 T.ARM2/ INITIAL
###.## 
###.## mm
T:
VACUUM ON
BLOW ON
WATER ON
Leveling stone
<P
N>
VAC:
### kPa
VACUUM OFF
BLOW OFF
WATER OFF
Set
screw