3D Shape Engineering Motorized Camera Slider v1 Documentation & Instrusctions - Page 6

Browse online or download pdf Documentation & Instrusctions for Camera Accessories 3D Shape Engineering Motorized Camera Slider v1. 3D Shape Engineering Motorized Camera Slider v1 7 pages.

Print Page

3D Shape Engineering Motorized Camera Slider

Documentation & Instructions

Specifications

Input Voltage: 7 .4 - 8.4 volts

Battery Life: Varies Per Battery Capacity

Slider Travel Length: ~1000mm

Maximum Rate of Speed: 62mm/s or 2.4"/s

Minimum Rate of Speed: 0 .016mm/s or 0.0006"/s

Time to span entire length of slider : 15 seconds - 16 hours

Slider Plate Weight Limit: 5-6 lbs or 2.7 kg

Troubleshooting

1. The Electronics Module will not power on. - E nsure the batteries are

oriented correctly (see diagram on the battery caddy) and that they are fully

inserted into the battery caddy, stopping at the line marked by the arrow in

the center. Double check that the batteries are charged up properly.

2. The motor does not move or hold position when electronics module is

powered on. - R eseat the motor connector firmly into the motor port. Ensure

none of the wires of the motor pin have separated from the motor connector.

3. The slider plate struggles to move / the motor is making strange noises -

Check to make sure that the stopper bolt is loose and not engaging with the

slider frame.If that doesn't work, you may have to reduce the weight of your

camera setup to a usable weight limit. (Typically 5-6lbs)

4. The electronics box / motor is really hot or smoking. - D isconnect the

battery caddy from the electronics module if safe to do so. If the batteries are

hot, put them in a place far away from flammable items.

5. The slider plate movement is no longer smooth. - E nsure the slider track

where the wheels make contact as well as the wheels themselves are clean of

any dirt or debris. Use only isopropyl alcohol to clean the wheels / track.

Warranty

We offer a 1 year limited warranty that is included with the initial purchase of this

product. Any persons making a warranty claim must have the original receipt / order

number of the purchase for the warranty to be honored. This limited warranty

coverage may change at any time and is up to the discretion of 3D Shape

Engineering. In order to place a warranty claim, please contact us at

[email protected] or 3 dshapeengineering.com/pages/contact-us

This warranty currently covers these issues up to (1 year) after purchase:

❖ Electronic / Mechanical failure caused by manufacturing defects.

❖ Excessive mechanical wear caused by normal usage.

❖ Physical damage caused by shipping and / or normal usage.

The warranty is void under the following conditions:

3dshapeengineering.com