3D Shape Engineering Motorized Camera Slider v1 Dokumentacja i instrukcje - Strona 6

Przeglądaj online lub pobierz pdf Dokumentacja i instrukcje dla Akcesoria do kamer 3D Shape Engineering Motorized Camera Slider v1. 3D Shape Engineering Motorized Camera Slider v1 7 stron.

 
3D Shape Engineering Motorized Camera Slider 
Documentation & Instructions 
Specifications 
Input Voltage: ​ 7 .4 - 8.4 volts  
Battery Life:​ Varies Per Battery Capacity 
Slider Travel Length:​ ~1000mm 
Maximum Rate of Speed:​ 62mm/s or 2.4"/s 
Minimum Rate of Speed: ​ 0 .016mm/s or 0.0006"/s 
Time to span entire length of slider​ : 15 seconds - 16 hours 
Slider Plate Weight Limit:​ 5-6 lbs or 2.7 kg 
 
Troubleshooting 
 
1. The Electronics Module will not power on. - ​ E nsure the batteries are 
oriented correctly (see diagram on the battery caddy) and that they are fully 
inserted into the battery caddy, stopping at the line marked by the arrow in 
the center. Double check that the batteries are charged up properly. 
2. The motor does not move or hold position when electronics module is 
powered on. - ​ R eseat the motor connector firmly into the motor port. Ensure 
none of the wires of the motor pin have separated from the motor connector. 
3. The slider plate struggles to move / the motor is making strange noises - 
Check to make sure that the stopper bolt is loose and not engaging with the 
slider frame.If that doesn't work, you may have to reduce the weight of your 
camera setup to a usable weight limit. (Typically 5-6lbs) 
4. The electronics box / motor is really hot or smoking. - ​ D isconnect the 
battery caddy from the electronics module if safe to do so. If the batteries are 
hot, put them in a place far away from flammable items. 
5. The slider plate movement is no longer smooth. - ​ E nsure the slider track 
where the wheels make contact as well as the wheels themselves are clean of 
any dirt or debris. Use only isopropyl alcohol to clean the wheels / track. 
 
Warranty 
We offer a 1 year limited warranty that is included with the initial purchase of this 
product. Any persons making a warranty claim must have the original receipt / order 
number of the purchase for the warranty to be honored. This limited warranty 
coverage may change at any time and is up to the discretion of 3D Shape 
Engineering. In order to place a warranty claim, please contact us at 
[email protected]​ or ​ 3 dshapeengineering.com/pages/contact-us 
 
This warranty currently covers these issues up to (1 year) after purchase: 
❖ Electronic / Mechanical failure caused by manufacturing defects. 
❖ Excessive mechanical wear caused by normal usage. 
❖ Physical damage caused by shipping and / or normal usage. 
 
The warranty is void under the following conditions: 
©2018 3D Shape Engineering 
3dshapeengineering.com