Altman GALLERY SERIES Quick Start Manual - Page 10

Browse online or download pdf Quick Start Manual for Lighting Equipment Altman GALLERY SERIES. Altman GALLERY SERIES 20 pages.

Print Page

Gallery Series

Smart Track Models

To connect Smart Track models to track:

Step 1. If not done at factory, connect AC

wiring as shown in Figure 7. Also refer

to Table 1

"Input Wiring on page 8

Step 2. As shown in Figure 8, connect fixture

to track as follows:

A. Turn Knob A Clockwise 90 Degrees for physical

mechanical attachment.

B. Turn Knob B Clockwise 90 Degrees for circuit #1

power

C. Turn Knob B Counterclockwise 90 Degrees for

circuit #2 power.

IMPORTANT! Ensure that the track head is fully seated into the track prior to moving to the next step.

Portable Models

Portable models are supplied with a locking IEC power input connector. Similar to other electronic devices. This

type of connector is used due to its reliability and inability to cross the main / neutral / ground connections. IEC

ac input cables are readily available through most electrical /electronic retailers around the world. One molded

VLock IEC to Edison 2 meter (6'-6") cable (part number 54-VL012405200) is included with portable units

Note: Some models are Mains dimmable models. These units are for 120VAC markets only and a list of

approved dimmers is listed in

To connect power to Portable Models:

Step 1. Make sure the AC cable is not connected to an AC power source.

Step 2. As illustrated in Figure 9, position AC input cable in direct relation to the IEC connector on the side

luminaire top box assembly.

Step 3. Press AC input cable IEC connector firmly into IEC connector on top box assembly.

Step 4. The luminaire is now ready to connect to an AC source.

Figure 9: IEC Connector - Portable Models

Page 10

Ground /

Earth

Figure 7: Track Adapter Power

Table 2 on page

NOTES:

Portable Model Top Box

IEC Connector (AC Input)

Main / Line

Neutral

Wiring

• Luminaire not shown for clarity.

• Top boxes are not removable (from standard models)

and cannot be remotely located.

• Remote top box configurations are available for portable

units only. Remote top box models must be ordered

specifically as a remote top box set up. Remote top box

units have a one (1) meter cable between the luminaire

engine and top box. Refer to the Altman Lighting web

site

www.altmanlighting.com

Quick Start Guide

Figure 8: Installing Fixture on

Track

for more details.