Baltech VP-3410 Operation Manual - Page 9

Browse online or download pdf Operation Manual for Measuring Instruments Baltech VP-3410. Baltech VP-3410 12 pages. Vibration meter
Also for Baltech VP-3410: Operation Manual (16 pages)

Print Page

2.3 Work with the device

2.3.1 Preparation for measurement procedure

Before you start measuring, make sure, that the battery is

not low. If necessary, replace it. Remove the shield from the

magnet before mounting the sensor.

2.3.2 Sensor mounting

The vibration meter BALTECH VP-3410 uses the acceleration

sensor, which is connected to the electronic device via low

noise cable. The sensor can be mounted on the

measurement object in the following way:

1. Mounting with a magnet is used for performing ordinary

measurements with relatively accurate measurement

results. When operating with the magnet, make sure, that

the sensor is connected to the magnet tightly.

2. Mounting with a probe, when there is little space for

mounting the magnet, or when the measurement object is

nonmagnetic. The probe is connected to the sensor with the

help of thread connection. When measuring, make sure, that

the sensor and the probe are mounted on the measurement

object tightly. This measurement method is not applicable

when operation with high-frequency band.

3. Mounting on the pin for measurement of high-frequency

vibration.

Connect the sensor cable

to the electronic unit

(make sure, it is fixed).

sensor

magnet