Baltech VP-3410 운영 매뉴얼 - 페이지 9

{카테고리_이름} Baltech VP-3410에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Baltech VP-3410 12 페이지. Vibration meter
Baltech VP-3410에 대해서도 마찬가지입니다: 운영 매뉴얼 (16 페이지)

페이지 인쇄

2.3 Work with the device

2.3.1 Preparation for measurement procedure

Before you start measuring, make sure, that the battery is

not low. If necessary, replace it. Remove the shield from the

magnet before mounting the sensor.

2.3.2 Sensor mounting

The vibration meter BALTECH VP-3410 uses the acceleration

sensor, which is connected to the electronic device via low

noise cable. The sensor can be mounted on the

measurement object in the following way:

1. Mounting with a magnet is used for performing ordinary

measurements with relatively accurate measurement

results. When operating with the magnet, make sure, that

the sensor is connected to the magnet tightly.

2. Mounting with a probe, when there is little space for

mounting the magnet, or when the measurement object is

nonmagnetic. The probe is connected to the sensor with the

help of thread connection. When measuring, make sure, that

the sensor and the probe are mounted on the measurement

object tightly. This measurement method is not applicable

when operation with high-frequency band.

3. Mounting on the pin for measurement of high-frequency

vibration.

Connect the sensor cable

to the electronic unit

(make sure, it is fixed).

sensor

magnet