ESI KATA2-MS-DC-BLK Installation Instructions Manual - Page 5
Browse online or download pdf Installation Instructions Manual for Racks & Stands ESI KATA2-MS-DC-BLK. ESI KATA2-MS-DC-BLK 8 pages. Dual monitor arm with sliders
Print Page
Kata2-MS
Step #5: install lockout set screws, if desired
Default rotation of the monitor arm assemblies
is 360°. Installation of lockout set screws limits
rotation to 180°.
• To lockout rotation of a monitor arm assembly,
install a set screw in the upper hole in the
recessed portion of the straight arm. Tighten
the screw, then back it off one turn.
• The monitor arm assembly must be in its
allowed range of rotation when installing
the lockout set screw.
Step #6: organize cables and cords
• Remove the cable covers from each monitor arm by sliding
them upward.
• Capture the cables and cords with the cable covers. Slide the
cable covers downward to attach them to the monitor arms.
• Snap the cable clips into groove at the bottom of the straight
arms. Position the opening on the clips toward the rear.
• Route the monitor cables and power cords toward the rear
by slipping the cords into the opening on the cable clips.
remove cable
covers
slide up
monitors
not shown
M4x9
dual Allen key
2mm end
install covers
over cables
slide
down
Page 5
180°
capture
cables
with clip
Assembly
snap on
cable clip