ESI KATA2-MS-DC-BLK Installation Instructions Manual - Page 6

Browse online or download pdf Installation Instructions Manual for Racks & Stands ESI KATA2-MS-DC-BLK. ESI KATA2-MS-DC-BLK 8 pages. Dual monitor arm with sliders

Print Page

Kata2-MS

Step #7: make any necessary adjustments

There are five possible ways to change the position of the monitors to maximize the efficiency and comfort of the working environment:

1. Monitor position on slider

— To move the monitors from side-to-side, use the 2mm end of the dual Allen key to loosen the set screw (M4x9) on the bottom of the VESA mount assembly, then

slide the monitor along the slider bar. Do not loosen the set screw more than one full turn — the tip of the set screw must remain inside the groove on the slider bar

so that the mount assembly cannot slide off the ends. Re-tighten the set screw when the monitors are positioned where desired.

2. Monitor swivel

— Use the 4mm end of the dual Allen key to adjust the underside screw behind the slider bar for the desired ease of monitor rotation.

3. Monitor arm swivel

— Use the 2mm Allen key to adjust the bottom set screw (M4x6) in the recessed area of the straight arm for the desired ease of rotation.

4. Monitor tilt

— To change monitor tilt angle, use the 4mm Allen key to loosen the screw on the side of the VESA mount. Tighten the screw to hold the angle.

5. Motion arm weight adjustment

— Use the 4mm Allen key to adjust the screw at the top of the fixed arm for the appropriate monitor weight. When adjusted properly, the monitor weight is balanced,

making it easy to raise or lower the monitor.

behind

slider

M4x6

Page 6

Assembly

monitors

not shown