1 BY ONE Audio-Technica AT3600 Instruction Manual - Page 7

Browse online or download pdf Instruction Manual for Turntable 1 BY ONE Audio-Technica AT3600. 1 BY ONE Audio-Technica AT3600 14 pages. Belt drive turntable with built in speakers

Power Management Function

The turntable will automatically go into standby mode after 20 minutes of inactivity.
The indicator light will turn off.
To resume operation, turn off the power switch and turn on again.

Playing a Record

1. Before playing a record
1.1 Pull the protector straight forward to remove it.
NOTE: Applying a downward force may cause
the stylus to come off the body. Only low
volume is outputted if the stylus has come off,
or is about to come off, so refer to "Replacing
the stylus" to reattach the stylus correctly.
1.2 Place the record on the felt mat so that the center hole aligns with the spindle.
2. Turntable Operation
Sufficiently lower the volume of the amplifier and speakers first.
2.1 Connect the included power adapter to the turntable and turn the power switch
to the "ON" position. The turntable will turn on.
2.2 Remove the stylus protector from the stylus.
2.3 Place the record on the slip mat. If using 45RPM records, put the 45RPM
adapter on the center spindle before placing the record on the platter.
2.4 Slide the 33/45RPM Selector according to the type of record.
2.5 Slide down the BT/LP Mode Selector to choose LP mode. The Red indicator light
indicates LP mode and blue indicator light indicates Bluetooth mode.
Protector
10
2.6 Slide up the Play/Stop Switch. The platter will start spinning.
2.7 Unlock the tonearm clip and set the tonearm lift lever to the up position.
2.8 Position the tonearm over the desired location (groove) on the record.
2.9 Set the tonearm lift lever to the down position and carefully lower the tonearm
on the record.
2.10 Turn up the volume of the turntable as needed.
2.11 When you are finished playing the record, set the tonearm lift lever to up position,
raise the tonearm and return it to rest on the arm clip. Slide down the Play/Stop
switch to stop.
NOTE:
1. If the silent pause time between each track is longer than 3 minutes, the platter
will stop spinning automatically to avoid damaging the record. This stoppage
does not mean the turntable is defective.
2. If the felt mat gets dirty, it can easily scratch the record, so remove the felt mat
periodically and wipe off any dust.
3. To prevent the record from getting scratched and warping, remove it after use.
4. Do not use a disk stabilizer.

Bluetooth Operation

1. Connect the included power adapter to the turntable and turn the power switch to
the "ON" position.
2. Slide up the BT/LP Mode Selector to choose Bluetooth mode. The indicator light will
turn blue and flash quickly. You will hear an activation sound from the turntable.
3. Turn on the Bluetooth feature of your media device and search for and select
"1byone BS008" to pair the media device and turntable.
4. Once your media device is successfully paired with the turntable, the turntable will
play a short confirmation sound. The blue indicator light will flash slowly.
5. Play and stream music from your media device to the turntable. The indicator light
will become solid.
Note: Bluetooth version: 5.0
11