ClearSpan R030B00007 Manual - Page 7

Browse online or download pdf Manual for Tent ClearSpan R030B00007. ClearSpan R030B00007 11 pages. Corrugated polycarbonate end panel kit 30' wide & 35' wide

Print Page

END PANEL INSTALLATION (continued)

With the lower panels installed, repeat the steps as

needed to measure, cut, and attach the first upper

panel. Consult the Polycarbonate Panels diagram for

your end panel kit to determine which panel to cut and

panel position.

NOTE: All upper panels should extend approximately

6" below the brace where the upper and lower panels

meet. See diagrams for details.

10.

Hold the first pre-cut panel in place and trace along

the end rafter to mark where to cut the panel so it

fits under the end cap. See the end cap diagram that

follows Step 2.

11.

Remove panel, cut along traced line, and set panel

back into position by tucking the top edge under the

end cap. The bottom edge of the upper panel overlaps

the top edge of the lower panel.

12.

Verify that the panel is in the desired position (UV-

protected side toward the sun) and attach it to the end

frame using Tek screws and washers.

13.

Repeat the steps for the remaining upper panels.

Verify panel and panel position by consulting the

diagrams in the Quick Start section for your end panel

kit.

14.

Continue by reading the care and maintenance

section that follows.

Approximately 6" from top of

brace to the bottom edge of the

upper row of panels.

Top of Brace

Revision date: 06.04.10

End Panel Installation

Top Edge of Lower Panels

Lower Edge

of Upper

Panel

GROUND LEVEL

35' Wide End Wall

Bottom

Edge of

Upper

Panel

Trim excess panel

Upper Panel

Secure panel by installing Tek screws through both the

upper and lower panels and into the end wall brace.

GROUND LEVEL

Sample 35' End Wall Complete

Upper Panel

Mark and Cut

to Length

Tek screws

and washers

Length of

Upper Panel

(at center)

GRO