ClearSpan 105366 Manual - Page 9

Browse online or download pdf Manual for Greenhouse Kit ClearSpan 105366. ClearSpan 105366 13 pages.

Print Page

INSTALL FILM END PANELS

Gather the parts:

•

End panel film

•

Poly latch U-channel (#102197)

•

Spring for U-channel (#102198)

•

Tek screws (#FA4482)

View the diagrams to install the poly latch U-channel and

attach the end panel film.

1. Using Tek screws, attach sections of the poly latch U-channel along the outside

of the frame base and to the door header as shown in the diagrams.

NOTE: If main cover is installed, uninstall the main cover from the U-channel on

the end rafter. Reinstall main cover after end film has been installed.

2. Unfold and position the end film over the end rafter. Drape some of the material

over the top rafter leaving enough to reach the ground plus 6" - 12". Center the

film so equal excess material is on each side of the shelter. Tape can be used to

temporarily hold material in place if needed.

3. Once end film is in position, attach the film to the rafter. Starting at the top of the

end rafter and working your way down each side, wiggle the wire spring back and

forth to seat the spring into the previously installed U-channel, holding the film in

place. Be sure to pull the film tight while working down the end rafter.

4. Install the spring into the U-channel

attached to the door header and along

the frame base. Pull the film snug while

installing the spring.

CAUTION: Risk of Injury

Always wear eye protection when

installing the 102198 spring!

Step 1

102197

FA4482B

Space Tek screws evenly about 24" apart.

Revision date: 04.01.10

End panel installed. View as seen from outside the building.

Drawing may show a different but similar model.

Step 1

Ground Level

View as seen from outside the building.

CLEARSPAN

END FRAME KIT

™

Poly Latch

U-channel

and Spring

Installed

Step 4