ClearSpan 105366 Посібник - Сторінка 9
Переглянути онлайн або завантажити pdf Посібник для Комплект для теплиці ClearSpan 105366. ClearSpan 105366 13 сторінок.
Друкувати сторінку4
INSTALL FILM END PANELS
Gather the parts:
•
End panel film
•
Poly latch U-channel (#102197)
•
Spring for U-channel (#102198)
•
Tek screws (#FA4482)
View the diagrams to install the poly latch U-channel and
attach the end panel film.
1. Using Tek screws, attach sections of the poly latch U-channel along the outside
of the frame base and to the door header as shown in the diagrams.
NOTE: If main cover is installed, uninstall the main cover from the U-channel on
the end rafter. Reinstall main cover after end film has been installed.
2. Unfold and position the end film over the end rafter. Drape some of the material
over the top rafter leaving enough to reach the ground plus 6" - 12". Center the
film so equal excess material is on each side of the shelter. Tape can be used to
temporarily hold material in place if needed.
3. Once end film is in position, attach the film to the rafter. Starting at the top of the
end rafter and working your way down each side, wiggle the wire spring back and
forth to seat the spring into the previously installed U-channel, holding the film in
place. Be sure to pull the film tight while working down the end rafter.
4. Install the spring into the U-channel
attached to the door header and along
the frame base. Pull the film snug while
installing the spring.
CAUTION: Risk of Injury
Always wear eye protection when
installing the 102198 spring!
Step 1
102197
FA4482B
Space Tek screws evenly about 24" apart.
Revision date: 04.01.10
End panel installed. View as seen from outside the building.
Drawing may show a different but similar model.
Step 1
Ground Level
View as seen from outside the building.
CLEARSPAN
END FRAME KIT
™
Poly Latch
U-channel
and Spring
Installed
Step 4
9