ClearSpan Premium Solar Star 104918 Assembly Instructions Manual - Page 11
Browse online or download pdf Assembly Instructions Manual for Greenhouse Kit ClearSpan Premium Solar Star 104918. ClearSpan Premium Solar Star 104918 17 pages. Home-attached greenhouse
Print PageREMEMBER: The lower roof support plates are
attached to the top edge of the front panels.
Angled End
Panel
Install all roof panels with the extended polycarbonate
drip edge at the lower end of the panel.
The following diagram shows the union of the long roof
panel and the small front panel as seen from the outside
of the greenhouse. The lower roof support plates and the
3" x 3" square brackets secure roof panels.
Long Roof Panel
Panels are flush.
Dashed line indicates the
drip edge of the roof panel.
ATTENTION: Roof panels are flush with the end panels.
They do not rest on top of the end panels.
28. Secure the roof panels to the end panels using Tek
screws and 3" x 3" flat plates installed earlier.
Visit www.ClearSpan.com for additional products and customer assistance.
Roof Panel Drip
Edge
Hinged
Front Panel
Angled End
Panel
View shows the inside of the greenhouse from the back.
The arrows show the locations of the 3" x 3" flat plates
for the panel. These were installed in a previous step.
The roof panel (x) is secured to the end panel in the
same way. Dashed line represents the frame support
member that was installed earlier.
Diagram may show a greenhouse of a different length.
29. With the two outside panels in place and secured to
the lower roof support plates and to the end panels,
attach three (3) additional 3" x 3" square flat
brackets to each of the installed roof panels in the
locations shown in the next diagram.
REMEMBER: All 3" x 3" square flat brackets are
installed from the inside to the underside of the panels.
Diagram shows a longer greenhouse. Locations of the
flat brackets are the same for all greenhouse lengths.
30. Install the remaining long roof panel and secure it as
previously described.
x
10 of 16