ClearSpan Premium Solar Star 104918 Assembly Instructions Manual - Page 13

Browse online or download pdf Assembly Instructions Manual for Greenhouse Kit ClearSpan Premium Solar Star 104918. ClearSpan Premium Solar Star 104918 17 pages. Home-attached greenhouse

Print Page

34. From inside the greenhouse, attach each roof panel

to the roof plates using 3/4" Tek screws, and to the

end panel (using the previously installed 3" x 3" flat

brackets) and Tek screws as previously described.

NOTE: The arrows show where the 3" x 3" square flat

brackets were installed. View is from the back of the

greenhouse looking to the inside.

35. Attach two additional 3" x 3" square flat brackets to

the underside of the smaller roof panels in the

locations shown below.

36. Install the vented roof panel and secure as

previously described.

Visit www.ClearSpan.com for additional products and customer assistance.

37. With the greenhouse assembled as shown below,

return to the door and center and adjust it as needed

to ensure proper operation.

38. Using the long Tek screws and neo-bonded

washers, secure the door to the angled end panels.

Angled

End

Panel

Tek screws are installed through the doorframe and into

the square tubes of the angled end panels.

ATTENTION: The screws of the angled end panels that

were removed can be reinstalled. The doorframe of the

door however will serve to secure these panels.

39. After the door is secured, attach the solar-powered

vent openers to each of the vented panels.

NOTE: Consult the directions included with the solar-

powered openers to install these items. Install two (2)

openers for the vented roof panel.

40. After installing the vent openers, read the Foil Tape

and Silicone Sealant information and attach the

greenhouse flashing as described.

Tek Screw and

Neo-Bonded

Washer

Door

12 of 16