Altrex SHUTTLE Manual - Page 7

Browse online or download pdf Manual for Construction Equipment Altrex SHUTTLE. Altrex SHUTTLE 20 pages.

Print Page

4. Assembling the Shuttle

The Shuttle has two versions:

- Shuttle Carrier for transporting small goods with the plastic container upwards.

- Shuttle Solar to transport solar panels upwards.

In the latter case, one Solar end frame is used to easily get the panels onto the

work platform.

Even working height Assemble the scaffold according to step A1 in the

scaffold tower operating instructions.

Uneven working height Assemble the scaffold according to step A2 in the

scaffold tower operating instructions.

1. Mount the basic profile (Part B) level to the mounting frame and

secure it firmly with the clamps.

2. If the solar frame (Part A) is used as an end frame, the clamps

must be mounted 75 cm.

3. Slide the console (Part F / I) over the profile from the top and

lower it to the travel stop.

Tip! Mark the position of the clamps after the first time they are

mounted on the scaffolding frame so that assembly of the scaffolding

in combination with the solar frame will be faster next time.

4. Continue assembly of the scaffold as per steps B1/B2 in the scaf-

fold tower operating instructions.

5. After each repetition of step B1/B2 of the scaffolding, assemble

the next profile (Part D) and secure it with the clamps.

6. Check that the profiles are placed straight/level above each

other.

7. When the working height is reached, place, for using the

Shuttle Solar, the solar frame (Part A) on the same side as the

guide profile.

8. Mount the last profile (Part D) and secure it with the clamps.

9. Mount the edging board (see step C of the scaffolding

manual).

10. Mount the winch on the last guide profile with the clutch and

brake plate towards the scaffolding, and tighten it to the profi-

le.

11. Unlock the safety clutch by positioning the locking bar to the

left.

12. Lower the hoisting strop with the portable drill (powertool) in

combination with socket wrench M10.

13. Attach the lifting eye of the hoisting strop. Make sure that the

hoisting strop hangs neatly flat and straight and avoid twists.