Edic CR2 Operator's Manual - Page 5

Browse online or download pdf Operator's Manual for Ultrasonic Jewelry Cleaner Edic CR2. Edic CR2 9 pages. Professional restroom cleaner
Also for Edic CR2: Owner's/Operator's Manual (19 pages)

Print Page

Assembling the accessory racks:

The CR2 is shipped with the accessory racks and hard-

ware in the solution tank. When you receive your CR2,

it is necessary to secure the racks to the body. The only

tool required to complete this action is a Phillips head

screwdriver.

The CR2 comes equipped with threaded inserts pre-in-

stalled in the body. The two larger racks are installed

toward the front of the machine- one per side and the

two smaller racks are installed toward the rear, also one

per side.

Opening the machine:

This unit can be opened by simply removing two bolts

located on the back of the machine. The unit will open

forward by lifting up on the handle. If you need to open

the unit further, you may release the vacuum hose going

from the base of the vacuum plate to the bottom of the

recovery tank by loosening the hose clamp.

2 BOLTS

Installing an accessory heater:

If a 600HR Heat "n" Run heater system has been pur-

chased for the CR2, use the following illustration to

familiarize yourself with the heater.

1. Power switch- Lights up when switched to power

"ON"

2. "IN" hose connect to male Q.D. (Number 16 on page

3. Lamp will turn on anytime the heat element is ac-

tivated. Lamp will turn off any time max temp is

reached.

4. Male twist lock Pigtail- connects to 50 ft cord

5. "Out" male Q.D.- Connect to your 35ft solution line

6. Handle