Custom Crimp CC150MOB Series Operator's Manual - Page 12
Browse online or download pdf Operator's Manual for Crimp tool Custom Crimp CC150MOB Series. Custom Crimp CC150MOB Series 15 pages. Hose crimper with dial micrometer and 240 tons of crimping force has the capability to crimp up to 2" industrial hose
Print Page
CC150MOB
PROBLEM: CRIMPER RUNS BUT IS SLOW OR NON-FUNCTIONAL
•
Check supply voltage to see that it matches the voltage specified on the tag attached to the crimper.
•
If the crimper is connected to a three phase circuit, check all three legs of the circuit to be certain that all legs are
hot.
•
Measure the voltage to the crimper when the crimper is under load. Voltage should be a minimum of 90% of line
voltage when the crimper is under load.
Many performance problems are the result of low voltage or inadequate electrical service.
•
Check motor rotation and be certain that the motor rotates in the direction of the arrow on the motor housing. For
three phase units rotation can be reversed by switching any two wires in the plug.
•
The circuit in the crimper is protected by a thermal overload relay. If the relay trips after resetting it from the master
power switch, call for technical service.
PROBLEM: MOTOR RUNS BUT FOOT SWITCH WILL NOT OPERATE
•
Power to the secondary circuit is supplied from a 24 volt step down transformer. If the motor runs normally but the
foot switch will not function check the 2 amp slo blow fuse located in the control box.
PROBLEM: CRIMPER WILL CLOSE ON FITTING BUT DOES NOT DEVELOP POWER TO
COMPLETE THE CRIMP
•
Fitting is to large for selected crimp die. Select a crimp die that is closer to final crimp diameter. Machine has built-
in safety bypass to protect internal components from damage due to incorrect die selection.
•
Check oil level. Position dies to the fully open position and check oil sight glass in rear of machine. Be sure the oil
level is in the middle of the sight glass. Use ISO 32 or 46 weight hydraulic oil.
If problem(s) persist contact Customer Service for additional troubleshooting assistance
General Production Hose Crimper
TROUBLESHOOTING
12