3Jtech HSPA FWT WiFi AP Quick Setup Manual - Page 4

Browse online or download pdf Quick Setup Manual for Wireless Access Point 3Jtech HSPA FWT WiFi AP. 3Jtech HSPA FWT WiFi AP 4 pages.

Print Page
Ver 1.0.0.3
6.
Click on Apply after completing the setup. Wait 30 seconds around to have the new
settings taken effect.
7.
You can check if the HSPA FWT WiFi AP is online by clicking on the Management /
Status function. The information should be displayed under the Internet
Configurations section.

5. Restore Factory Default Settings

HSPA FWT WiFi AP provides a "RESET" button that will be easy for users to reset the AP to
default. The button is located at the front panel of the AP (See the figure below). Reset steps
are as follows:
(1) Press the RESET button 2 seconds around.
(2) All LEDs on the rear panel will flash 5 times.
(3) The AP will start to reboot.
NOTE: Disconnecting the power before resetting (which takes about 60 seconds) is complete might permanently
destroy the firmware. In this case of a damaged firmware, the unit will need to be replaced by customer
service.
4
Since 1988
RESET BUTTON