3Jtech HSPA FWT WiFi AP Handleiding voor snelle installatie - Pagina 4

Blader online of download pdf Handleiding voor snelle installatie voor {categorie_naam} 3Jtech HSPA FWT WiFi AP. 3Jtech HSPA FWT WiFi AP 4 pagina's.

Ver 1.0.0.3

Click on Apply after completing the setup. Wait 30 seconds around to have the new

settings taken effect.

You can check if the HSPA FWT WiFi AP is online by clicking on the Management /

Status function. The information should be displayed under the Internet

Configurations section.

5. Restore Factory Default Settings

HSPA FWT WiFi AP provides a "RESET" button that will be easy for users to reset the AP to

default. The button is located at the front panel of the AP (See the figure below). Reset steps

are as follows:

(1) Press the RESET button 2 seconds around.

(2) All LEDs on the rear panel will flash 5 times.

(3) The AP will start to reboot.

NOTE: Disconnecting the power before resetting (which takes about 60 seconds) is complete might permanently

destroy the firmware. In this case of a damaged firmware, the unit will need to be replaced by customer

service.

Since 1988

RESET BUTTON