DK-TEC SAVCDH User Manual - Page 12

Browse online or download pdf User Manual for Lawn Mower DK-TEC SAVCDH. DK-TEC SAVCDH 15 pages. Flail mower

DK-TEC SAVCDH User Manual
WARNING
Before connecting/disconnecting the hydraulic pipes, the engine of the tractor must be stopped.
Before connecting, turn off the hydraulic lines, stop the tractor engine and set both sensors in the
control levels to allow the oil to flow from the system.
Operating information
WARNING
Before operating the machine, make sure that there are no people within 70 meters of the machine.
Before exiting the tractor and during any maintenance operation, apply the parking brake, turn off
the engine and remove the ignition key from the ignition panel. Wait for all parts to stop
completely.
For a good result, we recommend working with a forward speed of 2.5 km/h on the grass round
and 2.0 km/h on crop residues.
During work, you must not make curves with the machine to the ground or work in the opposite
direction. Always lift the flail mower for changes of direction and curves and insert the power
supply first. During use, the flail mower can give way to dust emissions, in which case you are
working on dry ground. We recommend using tractors equipped with cabs with filters on the fan
system or using a suitable system to protect the respiratory tract, such as Dust masks or masks
with filter.
In the event of a breakdown, the user must stop operation immediately, turn off the engine and
remove the ignition key, and exit the tractor to investigate the problem. Only start operation again
when the cause of the breakdown has been found and resolved.
It is recommended that all maintenance operations be carried out by qualified and trained personnel
persons, with the machine disconnected from the tractor.
It is necessary to check daily the state of wear of the knives, hammers and their connection points.
If they are very worn or damaged, they are replaced immediately as their breakage can cause
dangerous protrusions of the components.
Front protection bar
The protective beams must always be in good condition to avoid possible throwing of materials
into the front zone.
Immediately replace such parts if bent or otherwise damaged. To replace the beams:
Unscrew the screw on the left side of the machine and grab the fixing bolts
Replace the damaged beams Use only original spare parts.

4. Maintenance

10