DK-TEC SAVCDH Руководство пользователя - Страница 12

Просмотреть онлайн или скачать pdf Руководство пользователя для Газонокосилка DK-TEC SAVCDH. DK-TEC SAVCDH 15 страниц. Flail mower

WARNING

Before connecting/disconnecting the hydraulic pipes, the engine of the tractor must be stopped.

Before connecting, turn off the hydraulic lines, stop the tractor engine and set both sensors in the

control levels to allow the oil to flow from the system.

Operating information

WARNING

Before operating the machine, make sure that there are no people within 70 meters of the machine.

Before exiting the tractor and during any maintenance operation, apply the parking brake, turn off

the engine and remove the ignition key from the ignition panel. Wait for all parts to stop

completely.

For a good result, we recommend working with a forward speed of 2.5 km/h on the grass round

and 2.0 km/h on crop residues.

During work, you must not make curves with the machine to the ground or work in the opposite

direction. Always lift the flail mower for changes of direction and curves and insert the power

supply first. During use, the flail mower can give way to dust emissions, in which case you are

working on dry ground. We recommend using tractors equipped with cabs with filters on the fan

system or using a suitable system to protect the respiratory tract, such as Dust masks or masks

with filter.

In the event of a breakdown, the user must stop operation immediately, turn off the engine and

remove the ignition key, and exit the tractor to investigate the problem. Only start operation again

when the cause of the breakdown has been found and resolved.

It is recommended that all maintenance operations be carried out by qualified and trained personnel

persons, with the machine disconnected from the tractor.

It is necessary to check daily the state of wear of the knives, hammers and their connection points.

If they are very worn or damaged, they are replaced immediately as their breakage can cause

dangerous protrusions of the components.

Front protection bar

The protective beams must always be in good condition to avoid possible throwing of materials

into the front zone.

Immediately replace such parts if bent or otherwise damaged. To replace the beams:

•

Unscrew the screw on the left side of the machine and grab the fixing bolts

•

Replace the damaged beams Use only original spare parts.

4. Maintenance