Alumax STIKSTALL 795 Series Installation Instructions Manual - Page 8

Browse online or download pdf Installation Instructions Manual for Enclosure Alumax STIKSTALL 795 Series. Alumax STIKSTALL 795 Series 10 pages. Shower enclosure

Print Page

- 790 DOORS ONLY

Insert the two nylon pivot bushings [Y] into

the pivot holes in the head and curb fillers [P].

Lift the door panel [L] and insert the top pivot pin

into the pivot bushing in the header filler. Hold the

door vertical and insert the bottom pivot pin into the

pivot bushing in the curb filler. It may be necessary

to remove the header retaining screws and raise the

header slightly to install the door.

When the door has been set into place, snap the

security washer [AA] over the top pivot pin to hold

the upper pivot bushing in place and prevent

accidental dislodging of the door.

- 790 DOORS ONLY

Cut the drip rail [R] to the length of the bottom

rail minus 11/16".

Clean the bottom door rail and the

drip rail thoroughly to ensure proper adhesion. Unroll

the double stick tape [V] and carefully apply it to the

back of the drip rail (do not peel the tape backing yet).

Insert the tapered drip vinyl [T] into the drip rail.

Position the drip rail flush with the bottom and pivot

side of the door panel [L], then raise the strike side

until the bottom edge of the drip vinyl is parallel to the

curb [A]. Mark the location of each end of the drip rail.

- 790 DOORS ONLY

Adjust the drip vinyl [T] by sliding it left or

right until it just touches the curb.

(flush with the pivot end and notch 1/4" longer

than the drip rail

as shown on the strike end).

The drip plug [S] is supplied with a left and right

hand plug together.

plug apart and insert the appropriate plug into

the high (strike) side of the drip rail.

unused drip plug.

carefully press the drip rail [R] to the door in the

marked position.

EPH-N00-06020

1-26-00

Trim the vinyl

Break the right and left drip

Discard the

Peel off the tape backing and

Page 8 of 10