Alumax STIKSTALL 795 Series Installation Instructions Manual - Page 9

Browse online or download pdf Installation Instructions Manual for Enclosure Alumax STIKSTALL 795 Series. Alumax STIKSTALL 795 Series 10 pages. Shower enclosure

Print Page

- 790 DOORS ONLY

Attach the interior door handle [BB] and

the exterior door handle [CC] to the door panel [L]

with two #6-32 x 1 1/4" round head screws [DD].

Close the door and check the clearance with the

strike jamb [ N].

If necessary, loosen the set

screws [W] on the top and bottom slide bars and

adjust the door panel to align the strike magnets.

When the door panel is properly aligned, tighten

the set screws securely.

- ALL DOORS

Inspect the pieces of black glazing vinyl,

and note the two different profiles.

shape [EE] is installed vertically and the larger

shape [FF] is installed horizontally.

strength and maximum water resistance, these

vinyls are designed to fit tightly between the glass

and framing.

To speed installation, use glass

cleaner for lubrication and a small block of wood to

press the vinyl into place.

- ALL DOORS

Cut four pieces of the smaller vinyl [EE] 1"

longer than the vertical opening (to prevent

gapping from shrinkage) and trim the ends on a

45° angle.

Using the masking tape guides, center

the glass panel [F] in the frame. Cut four short (1"

- 2") pieces of the small vinyl and press into both

jambs on each side to hold the glass temporarily.

Take one of the long pieces of vinyl, and starting

on the outside exterior jamb, press each end into

the frame and work toward the middle.

not to stretch the vinyl.

pieces in a similar fashion.

The smaller

For structural

Be careful

Install the other three

Page 9 of 10

FIXED GLASS PANEL

V-219

1/4" GLASS

REQUIRES:

V-226

3/16" GLASS

REQUIRES:

VERTICAL

HORIZONTAL

V-220

V-225

NOTCH

STANDARD SIZES

SHIPPED WITH

4 PIECE VINYLS

(TEAR APART)

EPH-N00-06020

1-26-00