Etac Molift Mover 300 L User Manual - Page 18

Browse online or download pdf User Manual for Mobility Aid Etac Molift Mover 300 L. Etac Molift Mover 300 L 20 pages.

Print Page

Molift Smart 300 L / www.etac.com

Cleaning and disinfection

Clean on a regular basis. Clean surfaces with

a damp cloth using an appropriate pH-neutral

detergent. Do not use solvents or strong liquids,

this may damage surfaces on the lifter. For

disinfection when needed; use isopropyl alcohol.

Avoid abrasive cleaning products. Remove hair

and pile from the castors and verify that the

castors rotates freely. Clean contact and hand

control with isopropyl alcohol to remove grease

and dirt. Check emergency stop and emergency

lowering after cleaning. The lift should not be

exposed to running water.

Make sure not to damage or

remove labels when cleaning.

Periodic inspection scope

Periodic inspection is a visual examination (particu-

larly of the lifter's load bearing structure and lifting

mechanism with attachments, brakes, controls,

safety devices and person-support devices) accord-

ing to Periodic inspection Report for Molift Mover

300 L. This can be found on www.etac.com.

If there is any problems with the

lifter that could jeopardize some-

ones safety, the lifter shall imme-

diately be taken out of service and

marked "out of order". Do not use

the lifter until it is repaired.

Periodic inspection shall be performed annually or

more frequently if required by local requirements.

The inspection must be performed by service

personnel authorized by Etac.

Contact Etac at [email protected] for training and

authorization or recommendation of an approved

service partner.

When performing a periodic inspection, the

inspector shall fill out the inspection report

for Molift Mover 300 L. The reports should be

Maintenance

Reconditioning

Follow cleaning and assembly procedure, complete

periodic inspection and use checklist after assem-

bly to recondition the lifter.

Recycling

Refer to "Recycling instructions" on how to

properly dispose of the product. "Recycling

instructions" can be found on www.etac.com.

Spare Parts

A list of spare parts is available on request.

Periodic inspection

retained by the person(s) responsible for servicing

the lifter. If the inspection reveals defects and

damages, the owner shall be notified.

When periodic inspection is completed the

inspector shall mark the lifter with a sticker on

the control label showing the date when periodic

inspection is performed and a label (with 6-digit

ID from Etac or distributor, if available) showing

who has performed the periodic control. The

control label can be found on the right side of the

battery holder, and this will then indicate the date

when next inspection is due.

Mark label

with month

and year of

inspection